Building Performance Starts With Nelson
Nelson Competition Assembly Room is where all the MAGIC comes together for our projects.
CV-616 allows for precision surface finish with consistent crosshatch angle in each cylinder. This is reliability second to none when building when building with precision.
Our in house SuperFlow bench is able to test any cylinder head, intake manifold, throttle body.
Our hot tank, or "parts washer" as we call it enables us to DEEP clean blocks and other engine parts Pre or Post machining and assembly..
Media blast cleaning, is a surface treatment process we use to surface prep parts for paint or to bring the part back to its raw state.
For maximum precision that corrects main cap distortion caused by warpage and cap stretch. This is how we keep things spinning!
The Sunnen DCB-200 Digitally controlled balancing machine is fast, accurate & extremely precise, eliminating any guess work. It employs a PC control with Windows based software for enhanced setup & operating versatility. Precisely balanced crank assembly
Honing benefits includes precision bore size and surface finish, allowing for a precision fit with the crankshaft and piston pin bearings. Aside from the obvious size control advantages of honing over boring or reaming, honing also provides a non-directio
Its often necessary to remove some material from this part of the block just to square up the cylinder heads. Also, the deck of the block must be perpendicular to the crankshaft centerline. A block should also be decked to ensure a good, flat surface so t
We make sure each cylinder is perfectly round and straight & perpendicular to the centerline of the crank. this allows us to understand that the cylinders are aligned.
The Serdi 100 seat and guide machine can cut seats in one pass while maintaining concentrically. This provides an excellent seat for the valves to seal against.
Cylinder head resurfacing is just one of the jobs that is required when rebuilding an engine or reconditioning a cylinder head. It is an extremely important job because the surface finish that is put on the head (and engine block) affects not only the hea
Usually used to machine flat surfaces, it can also produce irregular surfaces. They can also be used to drill, bore, cut gears, and produce slots and create flat surfaces..
We use this for various jobs.